Hardware

We have categorized our hardware products in 4 main categories. Within each category you can speed up your search process by selecting the type of product you would like to see. By default all product groups are selected - narrow your search by deselecting the product groups you don't want to see.

Humidity/Temp
Precipitation
Solar radiation
Wind
Barometric pressure
Soil moisture/Temp
Level gauges
Water quality
Air quality
Pipeline pressure
Miscellaneous

Adcon SM1 Soil Moisture Sensor

Adcon SM1 Soil Moisture Sensor

The new Adcon SM1 soil moisture sensor was developed to provide farmers with an inexpensive means to measure soil moisture in all kinds of soils and in a wide range of depths, from 30cm all the way down to 150cm. By default all models come with one sensor every 10cm.

Using the principle of capacitance measurement the SM1 has an unusually low power consumption, which allows several sensors to be connected to one RTU. At the same time its sphere of influences is larger than that of most probes, extending beyond a 10cm radius around the access tube.

The outer diameter of the access tube of only 32mm (1.25") allows for a quick and easy installation. Up to a length of 60cm the probe can usually be installed by pushing the access tube into an undersized hole, while beyond 60cm a slurry installation is recommended.

The sensor is built of a combination of two sensor boards, either 30cm long with 3 sensors, or 50cm long with 5 sensors. Each such sensor board also has a centrally located temperature sensor. Therefore each probe comes with up to 3 soil temperature sensors.

An SDI-12 interface provides compatibility to a large variety of data loggers, and allows cable runs of up to 60m according to the SDI-12 standard (allthough we don't really recommend to run cables that long).

To power the probe it requires any voltage between 5,5V and 12V DC. To connect to your Adcon RTU a 5m long Binder cable with a male 7-pin connector is included.

Technical Specifications

Measuring range soil moisture
0-100% Vol
Measuring range temperature
-20°C ... +60°C
Method HF Capacitance
Accuracy +/- 1% (with site specific calibration)
Interface SDI-12
Lengths 30, 50, 60, 90, 100, 120, 150cm
Number of Soil Moisture Sensors One every 10cm on all versions

Number of Temperature Sensors

30cm sensor: 1 at 15cm
50cm sensor: 1 at 25cm
60cm sensor: 2 at 15 and 45cm
90cm sensor: 3 at 15, 45 and 75cm
100cm sensor: 2 at 25 and 75cm
130cm sensor: 3 at 25, 75 and 115cm
150cm sensor: 3 at 25, 75 and 125cm

Power Supply

5.5 ...12VDC

Cable and connector 5m Binder cable, PUR, with 7-pin male Binder connector M9
Tube diameter 32mm (1.25"

Ordering Information

200.733.800 Adcon SM1 30cm SDI-12
200.733.801 Adcon SM1 50cm SDI-12
200.733.802 Adcon SM1 60cm SDI-12
200.733.803 Adcon SM1 80cm SDI-12
200.733.804 Adcon SM1 90cm SDI-12
200.733.805 Adcon SM1 100cm SDI-12
200.733.806 Adcon SM1 150cm SDI-12
200.733.807 Adcon SM1 130cm SDI-12

Informations to download
No documents available.
More options
Adcon Telemetry GmbH dividerVertical Inkustrasse 24 dividerVertical A-3400 Klosterneuburg Austria
Tel.: +43 (0)2243 38280-0 dividerVertical Fax.: +43 (0)2243 38280-6 dividerVertical E-Mail: This e-mail address is being protected from spambots. You need JavaScript enabled to view it