SDI-12 cable 7-pin M9 - open end: 5m, 10m

These cables are tailor-made to connect standard SDI-12 sensors to an ADCON RTU. While one side features the standard male 7-pin connector required to connect the sensor to I/O port A of your ADCON RTU Series 4 (e.g. A753 or A755), the open ends of the other side are readily equipped to connect to an SDI-12 sensor. Only the wires needed to address the digital port on I/O A are visible, the others are carefully protected by heat shrink tubes to avoid any interference with the analog ports. The cables are certainly well shielded. Their outer PUR shell protects the cable against UV radiation and guarantees a long lifetime.