toggle menu

Wind Sensor Set Vento1

Wind Speed, Wind Direction, Cross Bar

The ADCON Wind Sensor Set Vento 2 is tailor made for meteorological applications that require a maximum of accuracy over an extended measurement range, integrated into a very robust, yet low-maintenance body made of seawater resistant aluminum
Request a quote or advice

Wind Speed Sensor
The Wind Speed Sensor has a very low starting threshold of less than 0.4m/s, thanks to its low-friction bearings and its generously dimensioned aluminum cups. The rotating 3-cup unit can be replaced in the field. The sensor will measure speeds of up to 200 km/h.

Wind Direction Sensor
The Wind Vane employs an accurate hall sensor. The vane is also made of aluminum and, like the wind cups, is easily field replaceable.
Both sensors require very little maintenance and will remain within their specifications for many years.

To properly mount the sensors according to WMO requirements the set comprises of an 80cm wide mast mounting arm, complete with mounting brackets. Each cable comes with its own Binder cable plus a separate Y-cable. This allows individual replacement of sensors in case of maintenance or repair, but still occupies only one connector on your ADCON RTU.
Both sensors are also available as individual units. If ordered separately they will be delivered with individual mounting arms and a 2m Binder cable.

  • Professional meteorological stations
  • Agricultural and hydrographical weather stations
  • Wind Power Stations
Leaflet - Set Vento1 Wind Speed & Direction
Download PDF
Wind Speed:
Measuring principle: magnetic
Measuring element: 3-arm cup anemometer, aluminum
Measuring range: <0.4 ... 55,56m/s (1.44 ... 200km/h)
Accuracy: < ± 0.3m/s
Resolution: ± 0.1m/s
Starting value: < 0.4m/s (1.44 km/h)
Output signal 0 ... 2.5V DC
Case: sea water resistant aluminum
Temperature range: -40°C ... +70°C (non-icing)
Mounting: Bores with diameter of 30mm at max. 10mm wall strength
Weight: approx. 500g.
Standards: VDI 3786, sheet 2 / WMO No.8
Cable: Binder Germany, 1m, shielded, PUR
Connector: Binder M9 male 7-pin
Wind Direction:
Measuring principle: magnetic
Measuring element: aluminum wind vane
Measuring range: 0° - 360°
Accuracy: < ± 2°
Resolution: ± 1°
Starting value: < 0.4m/s (1.44 km/h)
Output signal 0 ... 2.5V DC
Dead angle: 4° ± 1°
Switching point: North
Case: sea water resistant aluminum
Temperature range: -40°C ... +70°C (non-icing)
Mounting: Bores with diameter of 30mm at max. 10mm wall strength
Weight: approx. 500g.
Standards: VDI 3786, sheet 2 / WMO No.8
Cable: Binder Germany, 1m, shielded, PUR
Connector: Binder M9 male 7-pin
Download PDF
Back